PSB-810EAV - IEI PSB-810EAV CPU Board. PCI Bus | Socket 370 | VGA | Audio

PSB-810EAV - IEI PSB-810EAV CPU Board. PCI Bus | Socket 370 |...

Request Quote
For Price

Part Number:: PSB-810EAV
Model Number:: PSB-810
Make:: IEI
Lead Time:: Available
Qty In Stock:: Available

IEI PSB-810EAV CPU Board. PCI Bus | Socket 370 | VGA | Audio | Ethernet Simple Type: CPU Board

Welcome to the PSB-810EAV Pentium® III, Celeron Single Board Computer. The PSB-810EAV board is a PCI form factor board, which comes equipped with high performance Pentium® III, Celeron™ ,VIA Cyrix®¢ » Processor and advanced high performance multi-mode I/O, designed for the system manufacturers, integrators, or VARs that want to provide all the performance, reliability, and quality at a reasonable price. In addition, the PSB-810EAV provides on chip VGA. The VGA which provides up to 1600x1200 resolution. The VGA memory is share main memory. An advanced high performance super AT I/O chip – ITE IT8712 is used in the PSB-810EAV board. Both on-chip UARTs are compatible with the NS16C550. The parallel port and IDE interface are compatible with IBM PC/AT architecture's. PSB-810EAV uses Intel 82559 Fast Ethernet Multifunction PCI Controller as LAN controller. The 82559 is a fully integrated 10BASE-T/100BASE-TX LAN solution with high performance networking functions and low power features. PSB-810EAV uses the advanced INTEL Chipset,810E which is 100% LPC/PCI software compatible chipset.with PCI 2.2 standard.

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

Features

Built-in VGA function with share memory architecture
Built-in VGA function with share memory architecture
Designed with Intel 810E chipset; support 133MHz FSB and Ultra DMA66 IDE interface
Designed with Intel® 810E chipset; support 133MHz FSB and Ultra DMA66 IDE interface
Intel 82559/82559ER 10/100Mbps Ethernet chip on board
Intel® 82559/82559ER 10/100Mbps Ethernet chip on board
PCISA golden edge with PCI signals only, fully compatible with ICP IP & IPX series backplane
PCISA golden edge with PCI signals only, fully compatible with ICP IP & IPX series backplane
Supports ATX power control function
Supports ATX power control function
Supports Intel Socket 370 base CPC from Celeron to Pentium III up to 133MHz FSB
Supports Intel® Socket 370 base CPC from CeleronTM to Pentium® III up to 133MHz FSB
Watchdog Timer
Watchdog Timer

Specifications

General

AC`97 Codec: Support two channel Left/Right Line IN/OUT, MIC IN, CD IN, and PC beep sound for buzzer.
BUS: PCISA connector with PCI signal only, compatible to Jump PISA Ver. 1.07
Chipset: Intel 810E(810/810DC-100)
CPU: Celeron™ 300 - 550Mhz or above Processor, Pentium® III(FC-PGA) 450 - 700Mhz or above Processor, VIA Cyrix 466MHz or above
DMA Channels: 7
Ethernet: IEEE 802.3u Auto-Negotiation support for 10BASET/100BASE-TX standard. Fast back-to-back transmission support with minimum interframe spacing. Connected to your LAN through RJ45 connector.
FDD: Single 2.88 MB, 1.44MB, 1.2MB, 720KB, or 360KB floppy disk drive.
FSB: Support 66/100/133MHz
Interrupt Channels: 15
Mouse: PS/2 Mouse Port on-board.
Operating Temperature: 0° ~ 60°C ( CPU needs Cooler)
Power Consumption: +5V @ 4.5A, +12V @ 0.2A (FCPGA PIII-500 and 128MB DRAM under 3Dmark99 testing)
Processor: VIA Cyrix III
RAM Memory: Single 168-pin DIMM sockets support SDRAM module. The max memory is up to 256MB.
Serial Ports: NS16C550 compatible UARTs x2
Ultra ATA/33/66 IDE Interface: Two PCI Enhance IDE hard drives. The south bridge ICH0/ICH supports Ultra ATA/33/66 IDE interface.
USB: 2
VGA Controller: Embedded VGA controller, share main
Watchdog Timer: can be set by 1,2,3… 255 seconds/minutes period. Reset or NMI was generated when CPU did not periodically trigger the timer. Your program use INT15 to control the watch-dog and generate a system reset.

Applications

None Available

Aliases

None Available

IEI Industrial Partner